Inspect products regularly for visible damage, cracks, wear, elongation, rust, etc. Protect all products from corrosion. The need for periodic inspections cannot be overemphasized. No product can keep operating at its rated capacity indefinitely. Periodic inspections help determine when to replace a product and reduce rigging hazards. Keep inspection records to help pinpoint problems and to ensure periodic inspection intervals.

Due to the diversity of the products involved and uses to which they can be put, it would be counterproductive to make blank recommendations for inspection procedures and frequency. Best results will be achieved when qualified personnel base the decision on information from rigging and engineering manuals and on experience from actual use in the field.

Frequency of inspection will depend on environmental conditions, application, storage of product prior to use, frequency of use, etc. When in doubt, inspect products prior to each use. Carefully check each item for wear, deformation, cracks or elongation, a sure sign of imminent failure. Immediately withdraw such items from service.

Rust damage is another potential hazard. When in doubt about the extent of corrosion or other damage, withdraw the item from service.

Destroy, rather than discard, items that have been judged defective. They might be used again by someone not aware of the hazard involved.

Additional warning and information on the wire rope, chain, cordage, blocks and tools can be found preceding each section. These should be read and understood thoroughly before using a particular item.